← Blog

Rain that never loops: how we make rain, wind and thunder without recordings

20 November 2026

Most rain sound apps play a recording. It is a few minutes long, and it repeats. After a while you start to notice the same drip, or the same car passing, and then you cannot stop noticing it.

It's Raining Somewhere works differently. It finds a place on Earth where rain is falling right now, and it makes the sound of that rain on your device as you listen. There are no recordings of rain, wind, thunder or sea in it. Nothing repeats, because nothing is played back.

This post explains how the three main sounds are made.

Rain: one drop at a time

The engine starts from the weather at the place you chose: how many millimetres of rain are falling per hour. From that it works out how many drops land near you each second and how big they are. Light drizzle is many tiny drops. A downpour adds larger, faster drops that hit harder.

Each drop then makes a sound that depends on what it hits:

The ground is not a guess. It comes from a satellite land-cover map of the place, so rain over a forest sounds different from rain over a harbour.

What we got wrong first

Our first versions sounded crackly, like static. We measured them against real recordings of rain and found the cause. It was not the drops themselves. It was the balance: far too much of the sound was above 2 kHz.

SurfaceOurs, share of sound above 2 kHzReal recordings
Hard ground67%5–18%
Grass56%about 18%

One reason was interesting. Research on rain falling on water reports a strong ring at about 15 kHz, made by tiny bubbles. We had built that in. But those measurements are made with microphones under the water. Very little of that ring gets out into the air, so a person standing by a pond hears mostly the splash. Once we turned the bubbles down to what reaches the air, water sounded like water.

We used the recordings only to measure against. None of them are in the app.

Wind: air makes no sound by itself

What we call the sound of wind is moving air meeting things: your ears, leaves, wires, the corners of buildings. So the engine does not play a "wind noise". It places those things around you and drives each one with the wind speed where it stands.

The weather data gives the wind 10 metres above the ground. At ear height it is weaker, and how much weaker depends on the land. Over open ground you get about 70% of it. Among buildings you get much less, and it is gustier. Over the sea it is strong and steady.

Gusts travel. A gust is created upwind and carried towards you at the speed of the wind, so a tree on the windward side is hit before you are. With headphones you can hear a gust cross the scene from one side to the other.

Thunder: the shape of the lightning

The usual way to make thunder is low rumbling noise that swells and fades. It never sounds right, and there is a reason. Real thunder has no shape of its own. What you hear is the shape of the lightning channel.

A lightning flash heats a crooked path several kilometres long, almost instantly. Every short piece of that path sends out its own sharp pulse of sound. You hear the nearest piece first and the farthest piece last, because sound takes about three seconds to travel one kilometre. So the bends and branches of the lightning become the rhythm of the thunder: the first crack, the separate claps, the long roll at the end.

For each flash, the engine draws a new channel, breaks it into pieces a few metres long, and adds up the pulse from every piece. A near strike cracks. A distant one only rumbles, because the air has absorbed the high sounds on the way. No two are the same.

Why bother

Because the sound follows the real weather. When the rain at that place gets heavier, you hear it get heavier. When the storm moves on, it stops, and you can go and find another one. A recording can't do that.

Listen to the rain falling somewhere right now. It's free and has no ads. Headphones help. For the data sources and the rest of the details, see the About page.